Phillips screwdriver at the right side of the print mechanism. When the cutter blade returns to its standard position, a hole in the plastic gear will show up in the window as illustrated in diagram C below. Close the cutter cover when finish. The lock up of the print hood can then be released after this problem solved.
Please use manual cutter as temporary alternative measure once the auto cutter malfunctioned.
Alignment Window |
A | B | C |
Diagram C shows the correct alignment position to release the top cover.
Advanced Analysis Tool
This printer supports Hexadecimal Dump for experienced user to view exactly what data is received by the printer. This can be useful in finding software problems.
To start the dump mode: Turn off printer; Open print hood; Hold down FEED button while turning printer on; Close the hood.
To stop the dump mode: Press the FEED button to print out the last line; Turn off the printer.
During dump mode: All commands except DLE EOT and DLE ENQ are disabled.
USEFUL TIPS
∙Please note that only those qualified technicians may adjust several jumpers for some technical settings. Please visit our web site http://www.posiflex.com or http://www.posiflex.com.tw for details of the technical information such as driver installation, DIP switch settings and command sets etc. if required.
∙Place the printer on a sturdy, level surface.
∙Choose a place that is well ventilated and free of excessive dust, smoke or fume.
∙Do not put the printer under direct sunlight or near a heater.
∙Ideal room temperature is from 5ºC to 40ºC. Ideal humidity is from 20% to 85% RH (no condensation).
