2–Planning
Multiple Chassis Fabrics
2-8 59229-05 A
Domain ID, Principal Priority, and Domain ID Lock
The following switch configuration settings affect multiple chassis fabrics:
Domain ID
Principal priority
Domain ID lock
The domain ID is a unique number from 1–239 that identifies each switch in a
fabric. The principal priority is a number (1–255) that determines the principal
switch which manages domain ID assignments for the fabric. The switch with the
highest principal priority (1 is high, 255 is low) becomes the principal switch. If the
principal priority is the same for all switches in a fabric, the switch with the lowest
WWN becomes the principal switch.
The domain ID lock allows (False) or prevents (True) the reassignment of the
domain ID on that switch. Switches come from the factory with the domain ID set
to 1, the domain ID lock set to False, and the principal priority set to 254. Refer to
the Set Config Switch command in the SANbox 9000 Series Stackable Chassis
Switch Command Line Interface Guide for information about changing the default
domain ID, domain ID lock, and principal priority parameters.
If you connect a new switch to an existing fabric with its domain ID unlocked, and
a domain ID conflict occurs, the new switch will isolate as a separate fabric.
However, you can remedy this by resetting the new switch or taking it offline then
putting it back online. The principal switch will reassign the domain ID and the
switch will join the fabric.
NOTE:
Domain ID reassignment is not reflected in zoning that is defined by domain
ID/port number pair or Fibre Channel address. You must reconfigure zones
that are affected by domain ID reassignment. To prevent zoning definitions
from becoming invalid under these conditions, lock the domain IDs.