QSC Audio CX302, CX502, CX702, CX902, CX1102, CX254, CX404, CX204V, CX302V, CX602V, CX1202V

Gain Controls

The Gain controls are recessed and can be adjusted with a small screwdriver or flat tool. If desired, the Gain Con- trol Security Cover can be installed to prevent changes to the installer's settings.

Turn the gain controls clockwise to increase gain and counter clockwise to decrease gain. The maximum volt- age gain of the amplifier varies depending on the model designation. Maximum voltage gain for each model is shown on the front panel label in parentheses adjacent the 0dB attenuation setting.

The Gain controls are marked in dB of attenuation. There are 21 detents for repeatable adjustments. The upper 14 steps are about 1 dB each, and settings should normally be made within this range. The range below -14 dB should not be used for normal program levels, as the input headroom could be exceeded, but can be used for testing at reduced levels. At the minimum setting, the signal is completely cut off.

Gain Control Security Plate

The cover blocks access to the Gain settings. The LED indicators are still visible to monitor the system's opera- tion.

1.Use a 9/64" or 3.5 mm hex driver to loosen the screw several turns. Do not remove it completely.

2.Slide the right end of the cover under the loosened screw.

3.Insert the left end tabs into the last row of ventilation slots, and slide the panel fully to the right. It should lock into the slots.

4.Confirm that the LED's are visible through the cover. Tighten the hex screw carefully.

CX902 shown with gain control security plate installed.

Gain controls on 2-channel models. Markings will vary depending on model.

Gain controls on 4-channel models. Markings will vary depending on model.

EN

9