Honda Power Equipment HF2315SBE For achieving good, Put the machine onto a flat surface

MAINTENANCE			EN 47
! WARNING!	The blades differ and are contra-rotating.		4
			3
When installing them, make sure that they are correctly
positioned.			1
! WARNING!	When re-fitting		2
the blades, always follow the indi-
cated sequence, making sure that
the blades' wings are facing		1
towards the interior of the cutting
		2
deck and that the cupped side of
the cup washer (1) is pressing
against the blade. Tighten the fix-		2 1
ing screws (2) using a torque
wrench set to 45-50 Nm. If one or

both shaft hubs (3) come off when dismantling the blades, make sure the keys (4) are securely lodged in place.

6.3.2CUTTING DECK ALIGNMENT

	The cutting deck should be properly set
	to obtain a good cut.
24 - 28 mm	5 - 7 mm	NOTE	For achieving good
	results from cutting, the front part should
	always be 5 - 7 mm lower than the rear.
1	2
	–	Put the machine onto a flat surface
		and check the tyre pressures;
	–	aligned to the center lines of the two
		blades, put two blocks (1) 24-28 mm
1	2	thick under the front edge of the deck
		and two blocks (2) 5-7 mm higher
		under the rear edge;
	–	put the height adjusting lever into
		position «1».

➤

HF2315◊••

– Completely loosen the two nuts (3), the nuts (4 - 6 - 8) and the locknuts (5 -