Honda Power Equipment HF2315SBE, HF2417HTE Assembling The Levers For Tipping The Grass-Catcher

EN 12 UNPACKING AND ASSEMBLY

the wings (1a) are turned inwards.

Hook the upper part of the grass-catcher frame (5) onto the brackets and centre it up with the rear plate (2).

Adjust the position of the two brackets (1) to the stop (6) so that, when turning the grass-catcher frame, the pin (7) slots into the seat (8) correctly.

Check again that the frame (5) is properly centred with the rear plate (2) and that it rotates correctly, as shown above, and then fully tighten the screws (3) and the nuts (4).

5

1a

	1	2
6
	8
1	7	5

3.7 ASSEMBLING THE LEVERS FOR TIPPING THE GRASS-CATCHER

➤HF2•••HTE

Position the lever axle (1) in the notch of the two plates (2) and attach them on the internal side of the grass-catch- er supports (3), using the included screws (4) in the sequence shown.

Connect the end of the rod (5) of the lifting piston to the lever (6) with the pin

(7) and attach the two snap rings (8).

Before attaching the grass-catcher to its supports, make sure that the tipping lever moves properly.

4 314 3

4

4

1	2	8	7	5
	6			8