Honda Power Equipment HF2315HME same size to push the pin in the last part, Fitting The Seat

EN 10 UNPACKING AND ASSEMBLY

with the hole in the shaft and insert the pin supplied (3) using a hammer, ensuring that the end comes completely through to the opposite side.

NOTE To avoid damaging the steering wheel, use a punch of the

same size to push the pin in the last part.

3.3 FITTING THE SEAT

➤ HF2•••◊BE

Mount the seat (1) on the plate (2) using

the screws (3). 3

➤ HF2•••◊ME HF2•••◊TE

Raise the adjustment lever (3) and fit the seat (1) in the slide (2), introducing it from the steering wheel’s side, till the seat engages in one of the 6 positions.

At this point the seat is engaged and cannot be removed unless the lever (4) is pressed, freeing it from its retainer.

3.4 FRONT BUMPER ASSEMBLY (if fitted)

Fit the front bumper (1) on the lower part of the frame (2) using the four screws (3).

3.5 CONNECTING THE BATTERY

3	2
	1

4

2 1 3

2

1 3

The battery (1) is situated behind the engine and is held in place by an elastic strap (2). Unhook the elastic strap (2), remove the battery and its protective cover

(3) and pour the electrolytic solution (4) (Acid not supplied: specific gravity 1,280