R
4300 ACT Wood Stove Series
PEDESTAL OR LEG KIT INSTALLATION
WARNING: DO NOT OPERATE STOVE BEFORE FULLY ASSEMBLING ALL COMPONENTS. BURNING YOUR STOVE WITHOUT A PEDESTAL OR LEG KIT ATTACHED WILL VOID YOUR WARRANTY AND COULD PRESENT A SAFETY HAZARD.
PEDESTAL MODEL
1 Place protective pad or stove pallet on floor.
2.Lay body of stove on its back on protective pad or pallet.
3.Loosen screws on adapter and slide pedestal over adapter on bottom of stove
4.Line up holes in sides of pedestal with holes in adapter.
5.Securely tighten pedestal into place.
6.Carefully stand stove up and place in desired loca- tion.
7.Slip wooden decorative strips onto pedestal edges.
8.Open door of stove and check to make sure firebricks and ceramic blanket are in their proper locations (see pages
If installing legs, remove these screws to attach leg brackets to bottom of stove
Figure 17A
LEG MODEL
1.Remove leg mounting brackets packaged inside fire- box.
2.Place protective pad or stove pallet on floor.
3.Lay body of stove on its back on protective pad or pallet.
4Remove the bolts, using a 9/16” Hex Head socket or wrench, from the adapter and save.
5.Secure mounting brackets to the bottom of the stove with
Figure 17A.
6.Loosely assembly bolts into the corner of the mounting brackets.
7.Slide legs onto mounting brackets and tighten.
8.Carefully stand stove up and place in desired location.
9.Use leveling bolts on legs to stabilize and level stove.
10.Open door of stove and check to make sure firebricks and ceramic blanket are in their proper locations (see pages
LEG MOUNTING BRACKETS |
(packaged inside stove firebox). |
Figure 17B
CAUTION! DO NOT TILT THE UNIT ON THE CAST IRON LEGS. Lift the unit upright and place it into position on the floor protector.
Page 17 |
