Quadra-Fire 4300 WOOD STOVE SERIES Dimensions, Locating Your Stove, Vent Specifications

R

4300 ACT Wood Stove Series

DIMENSIONS

4300 MILLENNIUM MODEL

	25-1/2" (648mm)
9-1/2"	12-3/4"	28-1/2" (724mm)
(241mm)	(324mm)

C
L	25-1/2" (648mm)
	5-1/2" (140mm)	2-1/4" (57mm)
	C
	L

		10-15/16"
	19-1/16" (484mm)	(278mm)	Back of Stove to Glass
		14-15/16"
31-1/8"	15-1/16" (383mm)	(379mm)	24-11/16" (628mm)
(791mm)

18.0"(457mm)				16.0"
	10-3/16"
		(259mm)	(406mm) C
					L
						4-3/8" (111mm)

21.0" (533mm)

20-3/8" (518mm)

LOCATING YOUR STOVE

WHEN LOCATING YOUR STOVE consider safety, convenience, traffic flow, and the fact that the stove will need a chimney and chimney connector. It is a good idea to plan your installation on paper, using exact measurements for clearances and floor protection, before actually beginning the installation. If you’re not using an existing chimney, place the stove where there will be a clear passage for a factory-built listed chimney through the ceiling and roof.

AVOID FIRE: Maintain the designated clearances to combustibles. Insulation must not touch the chimney. You must maintain the designated air space clearance around the chimney. This space around a chimney is necessary to allow natural heat removal from the area. Insulation in this space will cause a heat buildup, which may ignite wood framing. NOTE: Clearances may only be reduced by means approved by the regulatory authority having jurisdiction.

WE RECOMMEND that a qualified building inspector and your insurance company representative review your plans before and after installation.

VENT SPECIFICATIONS

Single Wall: Six inch (6”) (152mm) diameter, minimum 24 MSG black or blued steel connector pipe, with a listed factory-built chimney type UL103 HT* suitable for use with solid fuels, or a masonry chimney, and the referenced clearances.

Double Wall/Mobile Home: Six inch (6”) (152mm) diameter, listed double wall air insulated connector pipe with listed factory-built UL103 HT* Class “A” chimney, or a masonry chimney (Mobile Home must be equipped with a spark arrestor), and the referenced clearances. Use only double-wall connector pipe, Dura-Vent DVL, Selkirk metalbestos DS or Security DL double wall connector.

*In Canada must comply with CAN/ULC-S269 for the 650° Factory-built chimney.

Page 6 250-7061C December 10, 2004