Quadra-Fire 4300 WOOD STOVE SERIES Brick Replacement Instructions, GLASS REPLACEMENT Part

R

4300 ACT Wood Stove Series

BRICK REPLACEMENT INSTRUCTIONS

The Step-Top Model accepts the Ash Removal System, and the brick pattern incorporates the ash grate.

The Millennium Model does not accept the Ash Removal System.

	3	2	2		3
	4		5
	1	1		1	4
	1				1
		4
				4	1
	6
1					6
	1		1		1
	4		4

Brick Set Part 831-1960

Nbr	Brick Size	Qty in Set
1	9 x 4.5 x 1.25”	10
2	9 x 4.5 x 1.25” with hole	2
3	9 x 3.0 x 1.25”	6
4	2.25 x 2 x 1.25”	1
5	6 x 3.25 x 1.25”	2
6	9 x 2.75 x 1.25”	2

3	2	2	3
3		4
1			3
	1	1
		1	1
1	1
			1
1	1	1
		1	1
	1

Brick Set Part 831-1970

Nbr	Brick Size	Qty in Set
1	9 x 4.5 x 1.25”	14
2	9 x 4.5 x 1.25” with hole 2
3	9 x 3.25 x 1.25”	4
4	2.25 x 2 x 1.25”	1

Use Part 832-0550 when ordering individual brick. Please provide brick dimensions or copy

this page and mark the desired brick and take it to your authorized dealer.

1.After the coals have completely cooled, remove all old brick and ash from unit and vacuum out firebox.

2.Remove new brick set from box and lay out to diagram shown above.

3.Lay bottom bricks in unit.

4.Install rear bricks on the top of the bottom bricks. Slide top of bricks under clip on back of firebox wall and push bottom of brick back.

5.Install side bricks. Slide top of brick under clips on side of firebox and push the bottom of the brick until it is flush with the side of the unit.

GLASS REPLACEMENT

Part 832-0060

Replace with 5mm ceramic glass only

1. Ensure that the fire is out and the stove is cool to the touch.

2.Protect a table or counter top with padding or towels.

3.Remove the door with the broken glass by lifting the door up and off of the hinges.

4.Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, on a soft surface.

5.Remove the screws from each glass retainer and remove the glass. (If screws are difficult to remove, soak with penetrating oil first).

6.Center the glass with edges evenly overlapping the opening in the door, (i.e. same space top and bottom, left and right sides).

7.Replace the glass retainers. Be careful not to cross thread the screws.

8.Tighten each retainer just a few turns until each is secured. Check again for centering of glass in door frame. Then continue to tighten each retainer alternately, a few turns at a time, until the glass is secured. DO NOT OVERTIGHTEN.

9.Replace the door on the appliance.

Page 24 250-7061C December 10, 2004