I V . A S S E M B L Y

INITIAL ASSEMBLY

Your power chair may require some assembly either before initial use or after transportation. It may also require disassembly to make some comfort adjustments.

NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or through your Quantum Rehab Provider.

Seat Installation

The Universal Mounting System (UMS) consists of universal parts that may be used on the Specialty Seat or any high-back seat, regardless of seat width or seat depth. The two main components are aluminum extrusions that can be mounted to the seat base. These extrusions attach to a pair of trapeze bars that are mounted to four steel towers.

NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat, or Synergy TRU-Balance, refer to the information provided in separate manuals. If your power chair is equipped with a contoured seating system, refer to the following information.

WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.

 

POWER SEAT BASE

FRICTION

SEAT LATCH SAFETY

LOCK LEVER

Figure 9. Universal Mounting System (Power Seat)

SEAT LATCH SAFETY

REAR TRAPEZE BAR

FRONT TRAPEZE BAR

REAR EXTRUSION

FRONT EXTRUSION

Figure 10. Universal Mounting System

18

www.pridemobility.com

Quantum 1121 Series

Page 18
Image 18
Quantum 1121 3MP, 1121 3SP manual A S S E M B L Y, Initial Assembly, Seat Installation