Quantum 1121 3SP, 1121 3MP manual To install the seat, Controller Harness Routing Contour Seat

I V . A S S E M B L Y

To install the seat:

1.Set the seat towers to the desired height. To change the seat height, see V. “Comfort Adjustments.”

2.Tilt the seat back, and slide the rear extrusion onto the rear trapeze bar.

3.Lower the front extrusion onto the front trapeze bar until the seat latches into place.

4.Flip the seat latch safety down.

WARNING! Make sure the seat latch safety is flipped down before using your power chair.

5.Install the controller into one of the armrests. See V. “Comfort Adjustments.”

6.Plug the controller harness into the connector on the electronics tray.

7.Route the harness to ensure that the harness cannot be pinched in the seat hinge. See figure 11 or 12.

8.Secure the controller harness to the armrest receiver with one or more wire ties.

MANDATORY! Prevent controller harness damage! Avoid routing the controller harness on the outside of the armrest pad. Route the harness under the armrest or toward the inside of the armrest pad. Use correct tie-down points for the controller harness to prevent the harness from getting caught in the drive tires, pinched in the seat frame, or damaged when passing through doorways.

WIRE TIES

Figure 11. Controller Harness Routing – Contour Seat

Figure 12. Controller Harness Routing – Synergy Seat

Quantum 1121 Series www.pridemobility.com 19