Quantum 1121 Series www.pridemobility.com 25
V. COMFORT ADJUSTMENTS
Figure 21. Toggle Switch
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating
seat, you can change the seat height either through the
controller or through the toggle switch mounted to one of
the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat.
See figure 21.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run
more than a few seconds after the
mechanism reaches the top or bottom
limit.
NOTE: For more information on operating the power
elevating seat through the controller, contact your
Quantum Rehab Provider.
WARNING! The power elevating seat option is intended for use on a level surface only. Never
raise the seat from its lowest position on an inclined surface. Failure to heed this warning can
result in the power chair tipping over.
WARNING! Never raise the seat from its lowest position when operating your power chair on
bumpy or uneven surfaces. Failure to heed this warning can result in the power chair tipping over.
WARNING! Never raise the power elevating seat while your power chair is in freewheel mode.
WARNING! Always fasten the positioning belt when operating the power elevating seat.
NOTE: The power elevating seat option is equipped with a system that reduces the speed of the power chair by
one half when the seat is elevated more than 1–2 in. (2.5–5 cm). Always check to be sure this system is operating
properly before using your power chair.
The power elevating seat is equipped with a swivel feature that allows the seat to be turned 90° to whichever side
the controller is located.
To use the swivel feature:
1. Locate the friction lock lever under the seat. See figure 9.
2. Pull back the friction lock lever to rotate the seat in 90° increments.
3. Pull the friction lock lever forward to latch the seat in place.
WARNING! Do not attempt to drive the power chair with the seat facing to the side. Always
return the seat to the forward facing position before operating the power chair.