I V . A S S E M B L Y
Seat Installation
It may be necessary to install the seat either prior to initial operation or after transporting your power chair. Most seats are attached to the power base with the Universal Mount- ing System (UMS). The UMS consists of universal parts that may be attached to any
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so, resulting in personal injury or damage to the chair.
To install the seat:
1.Tilt the seat back and slide the rear extrusion onto the rear trapeze bar. See figure 11.
2.Lower the front extrusion onto the front trapeze bar until the seat locks into place.
3.Flip the seat latch safety down. See figure 11.
WARNING! Make sure the seat latch safety is flipped down before using your power chair.
REAR |
EXTRUSION |
SEAT |
LATCH |
SAFETY |
REAR TRAPEZE |
BAR |
Figure 11. Universal Mounting System (FLIGHT Shown)
4.Install the controller and route the cable to the back of the power base. See figure 12.
5. Loosen the rear shroud fasteners counterclockwise one- quarter turn and remove the rear shroud. See figure 6.
6. Plug the controller connector into the power base. See figure 7.
7. Reinstall the rear shroud. Turn the rear shroud fasteners clockwise
8. Route the controller cable so that it cannot be pinched in the seat hinge.
9. Secure the controller cable to the armrest receiver with wire ties. See figure 13.
Figure 12. Remote Plus Controller Routed on a Synergy
Seat
22 | www.quantumrehab.com | Quantum 610 |
