V . C O M F O R T A D J U S T M E N T S

10.

Plug the controller connector(s) into the power base.

 

MOUNTING

11.

Reinstall the rear shroud and tighten the fasteners.

MOUNTING

SCREWS

 

 

BLOCK

 

Foot Platform Height Adjustment

 

 

The foot platform height is easily adjusted to different heights

 

 

in 1/2-in. increments.

 

 

To raise or lower the foot platform:

 

 

1.

Remove the quick release fasteners from the foot plat-

 

 

 

form bracket. See figure 19.

 

 

2.

Loosen the foot platform securement nut one-half turn.

 

 

3.

Raise or lower the foot platform to the desired height.

 

 

4.

Reinstall the quick release fasteners into the foot plat-

Figure 21. Mounting Block Controller Installation

 

form bracket and tighten.

 

 

 

5.

Tighten the nut to secure.

 

 

Foot Platform Depth Adjustment

 

LEVER (FULLY CLOSED)

To adjust the foot platform depth:

 

 

 

1.

Remove the quick release fasteners from the foot plat-

 

CAM

 

form bracket. See figure 19.

NUT

 

2.

Move the foot platform in or out to the desired depth.

BOLT

 

 

 

3.Reinstall the quick release fasteners into the foot plat- form bracket and tighten.

Quick Release Fasteners: The foot platform is attached

 

 

UNCLAMPED

CLAMPED

to the power base with two quick release fasteners. See

 

 

 

 

figure 19. Each quick release fastener consists of a bolt, a

 

 

 

 

lever, and a nut. See figure 22. The lever has a cam on the

 

 

LEVER (OPEN)

 

 

 

 

end that allows it to clamp into place. The quick release

 

 

 

 

 

fastener has two states: clamped and unclamped. When the

Figure 22. Quick Release Fastener Operation

lever is open, the quick release fastener is unclamped. When

 

 

 

 

 

 

 

 

the lever is closed, the quick release fastener is clamped.

 

 

 

 

To clamp the quick release fastener:

1.Make sure the lever is in the open position.

2.Turn the nut clockwise until it is snug.

3.Rotate the lever until it is in the fully closed position.

NOTE: If the lever will not rotate to the fully closed position, then turn the nut counterclockwise one-quar- ter or one-half turn.

Foot Platform Angle Adjustment

 

You can adjust the angle of the foot platform with a hex key.

JAM NUT

To adjust the foot platform angle:

SETSCREW

1. Flip up the foot platform and locate the setscrew and

Figure 23. Underside of Foot Platform

jam nut. See figure 23.

 

Quantum 610

www.quantumrehab.com

27

Page 27
Image 27
Quantum 610 owner manual Foot Platform Height Adjustment, Foot Platform Depth Adjustment, Foot Platform Angle Adjustment