| V . C O M F O R T A D J U S T M E N T S | ||
Armrest Width Adjustment |
|
| |
Youcanchangeeacharmrest’swidthindependentlyoftheother. |
|
| |
NOTE: Changing the armrest width may increase the | FOOT PLATFORM |
| |
overall width of your power chair. |
| ||
RETAINING PIN | SECUREMENT NUT | ||
To change the armrest width: |
|
| |
1. | Locate the two armrest knobs on each side of the arm- | FOOT |
|
| rest receiver bracket. See figure 18. |
| |
| PLATFORM |
| |
2. | Loosen the knobs. | BRACKET |
|
3. | Slide the armrests in or out to the desired width. |
|
|
4. | Tighten the knobs. |
|
|
Armrest Angle Adjustment | QUICK |
| |
To change the armrest angle: |
| ||
1. | Lift the armrest straight up so that it is perpendicular to | RELEASE |
|
FASTENERS |
| ||
| the floor. See figure 18. | SETSCREW |
|
2. | Loosen the jam nuts. |
|
|
3. | Turn the adjusting screw clockwise to lower the front | Figure 19. Foot Platform Adjustment |
|
| of the armrest, or turn the adjusting screw counterclock- |
|
|
| wise to raise the front of the armrest. |
|
|
4. | Tighten the jam nuts to lock the adjusting screw into | SETSCREW |
|
| place. |
| |
|
|
| |
Controller Position
You can position the controller for either
WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2.Turn the rear shroud fasteners counterclockwise one- quarter turn. See figure 6.
3.Remove the rear shroud.
4.Unplug the controller connector(s) from the power base.
5.Cutthewiretie(s)securingthecontrollercabletothearmrest. See figure 6.
6.Loosen the mounting screws in the mounting block. See figure 21.
7.Move the controller mounting block and controller to the other armrest and tighten the mounting screws.
NOTE: For contour seats, loosen the setscrew on the underside of both armrests, transfer the controller, and tighten the setscrews. See figure 20.
8.Route the controller cable to the back of the power base and plug in the controller. See figure 12.
9.Use wire ties to secure the controller cable to the seat frame. See figure 13.
26 | www.quantumrehab.com | Quantum 610 |
