28 Chloride Active and E-Series UPS User Manual
the equipment in service it must be absolutely dry. An acclimatization period of at least two hours is
required.
• This equipment must be installed in an indoor, temperature controlled environment that is free of
conductive contaminants. See chapter 19, “E-Series Specifications” on page 50 for specific
environmental limits.
• The special conditions for installing the hard-wired devices E61, E101 and E203 in chapter 13, “E-
Series Installation and Commissioning” on page 33 must be observed.
•The switch (see chapter 12, “Display and Operation Elements (E-Series)” on page 29) does not
isolate the device (UPS) from the mains. To isolate completely from the mains, the main switch must
be switched off and the power plug disconnected.
CAUTION: Removing mains power may not remove power from the device (UPS) output. See instructions above to
properly remove power from output.
• In case of interruption of the mains voltage, the integrated battery maintains the power supply to the
connected equipment.
• Lay all cables so that nobody can stand on them or trip over them. When connecting the device to the
power supply, follow the instructions in the chapter on “E-Series Installation and Commissioning” on
page 33.
• No data transmission lines should be connected or disconnected during a thunderstorm.
• Make sure that no objects (e.g. pins, necklaces, paper clips, etc.) get inside the device.
• In emergencies (e.g. damaged case, controls or power cables, penetration of liquids or foreign matter)
put the device into BYPASS, disconnect the power plug and contact Chloride Technical Services at
1-800-388-4234 or 1-847-990-3229. The special conditions for installing the hardwired devices, E61,
E101 and E203 are in chapter 13, “E-Series Installation and Commissioning” on page 33.
• Do not connect equipment that will overload the UPS (e.g. laser printers or vacuum cleaners) or
demand DC-current (e.g. half-wave rectifiers or hair dryers).
• When cleaning the unit, follow the instructions in chapter 16, “Maintenance (E-Series)” on page 47.
• The sum of the leakage currents (protective conductor current) of the UPS and the connected devices
must not exceed 3.5 mA for the types Active 700, 1000, 2000 and 3000.
Chloride Active and E-Series UPSs are UL listed under UL1778 for North American units.
11.4 Warning for E-Series E61, E101 and E203
This product may only be sold to users with qualified personnel. In order to avoid RF, restrictions for
installation or additional precautions may apply.