RAD Data comm AMC-101 operation manual Installation of a

Chapter 2 - Installation & Setup AMC-101Installation & Operation Manual

Figure 2-1 AMC-101 Rear Panel AC Version

	Figure 2-2 AMC-101 Rear Panel DC Version
Installation of a	Rack adapter components for installing a single unit include one short
Single Unit	bracket and one long bracket. Each bracket is fastened to the side walls of
	the unit by two screws (with flat washers) which are inserted into the two
	front holes on the side wall (The unit is supplied with nuts already in place
	on the inner side wall). Note that the short bracket fastens to the left side of
	the unit, and the long bracket to the right side of the unit (see Figure 2-3).
	Once the brackets are fastened to the side walls, the unit is ready for
	installation in the 19" rack. Place the unit in the rack and fasten the brackets
	to the side rails of the rack by means of the two screws situated on each side
	(not included in the kit).

Figure 2-3 Installation of a Single Unit

2-2 Site Requirements