Radio Shack 43-3801 owner manual Using ANNOUNCE-ONLY

outgoing message or recording an incoming message and resets to answer another call.

Notes:

•If the system’s memory is full, it answers calls after 10 rings. The caller hears “No one is available to take your call,” the system sounds a beep, and the caller cannot leave a message. The system cannot record additional messages until you delete some of the old messages (see “Deleting Messages” on Page 17).

•Many local phone companies use CPC to signal that the caller has hung up. Your system can recognize a CPC signal and release the line. If the system records phone company messages or dial tones, your local phone company probably does not use CPC.

USING ANNOUNCE-ONLY

Announce-only sets the system to play a message for the caller, then automatically disconnects without letting the caller leave a message.

To select announce-only, slide INCOMING MSG to ANN ONLY. When the system receives a call, it answers after two rings and plays the announce-only message, a long beep sounds, then it monitors the phone line for remote codes received within about 10 seconds.

You can use the system’s prerecorded announce-only OGM “No one is available to take your call,” or record your own.

Operation 13