Radio Shack 43-3801 owner manual Operation

To record a message, slide INCOMING MSG to ANN ONLY, then hold down HOUR/ANNOUNCE. After the beep, speak clearly into the microphone from about 10 inches in front of the system.

(The message can be about 30 seconds long.) Release HOUR/ ANNOUNCE to stop recording. The system automatically plays back your recorded message.

Notes:

•The announce-only OGM does not affect your original OGM that tells callers to leave a message. Each OGM can be recorded, played back, or deleted independently.

•The maximum length for an announce-only OGM is about 30 seconds. When it reaches the maximum outgoing message length, the system sounds a tone and plays back the message.

•If you record your own message and subsequently decide to use the prerecorded message, press HOUR/ANNOUNCE to play the message you recorded. While it is playing, press DELETE to erase your message.

•To hear the outgoing message at any time, press HOUR/ ANNOUNCE. To stop the outgoing message before it ends, press ON/OFF/STOP.

•When the system is set for announce-only, you cannot set it to record incoming messages using the remote commands.

To turn off announce-only so callers can leave messages, slide INCOMING MSG to either 1 or 5 MIN.

14 Operation