On a Wall Plate
Note: Check for the proper viewing an- gle of the liquid crystal display before mounting this system to a wall plate.
1.Plug one end of the supplied short modular phone cord into the TEL. LINE jack on the phone.
4.Plug the other end of the phone cord into the phone jack on the wall plate.
5.Align the phone stand’s keyhole slots with the wall plate studs and slide the phone downward until it snaps into place.
Illustration, | Illustration, |
connecting short line cord | mounting phone to wall plate |
2.Route the cord through the strain- relief slot on the back of the phone.
6.Slide out the handset holder, flip it over as shown, then slide it back into place.
Illustration,
routing cord through strain relief slot
3.Insert the tabs on the narrow end of the stand into the matching slots near the top of the phone, making sure the cord is routed through the opening in the stand. Then snap the stand into place by pressing in the two tabs toward the bottom of the phone.
Illustration,
connecting phone stand
Illustration,
flipping handset holder
8
