On a Wall
To mount the System 999 directly on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base.
Note: Check for the proper viewing an- gle of the liquid crystal display before mounting this system to a wall.
1.Drill two holes, one above the other, 31/4 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch from the wall.
1/8"
31/4"
2.Plug one end of the supplied long modular phone cord into the TEL. LINE jack on the phone.
Illustration,
connecting cord to phone
3.Route the cord through the strain- relief slot on the back of the phone.
Illustration,
routing cord through strain-relief slot
4.Insert the tabs on the narrow end of the stand into the matching slots near the top of the phone, making sure the cord is routed through the opening in the stand. Snap the stand into place by pressing in the two tabs toward the bottom of the phone.
Illustration,
attaching phone stand
5.Plug the other end of the modular phone cord into a modular phone jack.
6.Align the phone stand’s keyhole slots with the screws and slide the phone down until it snaps into place.
Illustration,
mounting phone on screws
7.Slide out the handset holder, flip it over as shown, then slide it back into place.
Illustration,
flipping handset holder
9
