2.Press the number buttons (and decimal button where appropriate) to enter the frequency.
If you make a mistake, press C (cancel) to erase the last digit.
If you wait more than 15 seconds to press a button, the previous fre- quency returns to the display and you must begin again at Step 1.
3.Press ENTER. The selected fre- quency appears.
Using the Rotary Dial
You can select a higher or lower fre- quency by turning the ROTARY TUNING knob up or down.
Set FAST/FINE/LOCK to select the rota- ry tuning increments or to lock the RO- TARY TUNING dial. If you select FAST, the rotary tuning increments are the same as when you use the MANUAL/
AUTO 
or 
keys. If you select FINE, the tuning increments are small-
er so you can fine tune the frequency, as shown in the following table.
Band | Fast | Fine |
|
|
|
|
|
|
FM | 0.1 MHz | 0.05 MHz |
|
|
|
LW | 9 kHz | 1 kHz |
|
|
|
MW (AM) | 9/10 kHz | 1 kHz |
|
|
|
SW | 0.005 MHz | 0.001 MHz |
|
|
|
You can also set FAST/FINE/LOCK to lock the ROTARY TUNING dial. This prevents you from accidentally chang- ing the frequency.
Note: This locks only the ROTARY TUNING dial. For information about locking the
10
