Radio Shack ET-1111 owner manual On a Wall Plate or Wall

43-1111.fm Page 7 Tuesday, June 29, 1999 3:38 PM

4.Route the adapter’s cord through the strain relief slot on the bottom of the base.

5.Plug the adapter into a standard AC outlet.

6.Lift the base’s antenna to a vertical position.

4.Plug the modular cord’s other end into the wall plate jack, then align the base’s keyhole slots with the wall plate studs and slide the base downward to secure it.

5.Plug the adapter into a standard AC outlet.

6.Press and lift out the handset hold- er, rotate it 180°, then snap it back into place so it holds the handset.

On a Wall Plate or Wall

1.Plug one end of the supplied short modular cord into the TEL LINE jack on the back of the base as in “On a Desk Top,” Step 1, on Page 6.

2.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack as in “On a Desk,” Step 3, on Page 6.

3.Route the adapter and modular cords through the grooves on the bottom of the base.

7.Lift the base’s antenna to a vertical position.

Note: To mount the ET-1111 directly on a wall, you need two screws (not sup- plied) with heads that fit into the keyhole slots on the bottom of the base.

Follow the steps under “On a Wall Plate or Wall,” then apply these additional in- structions for placement on a wall.

1. Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 5/16 inch (8 mm) from the wall.

7