Important: Be sure the battery pack is properly connected before you try to charge it.
Notes:
•When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear a
•Using a pencil eraser, clean the charging contacts on the handset and the base about once a month.
battery pack loses its ability to fully recharge.
•If the battery pack is completely dis- charged or the base loses power while the handset is away from it, place the handset on the base to reset the security
•The supplied battery pack should last about a year. When it loses its ability to fully recharge, order a replacement battery pack through your local RadioShack store (see “Replacing the Battery Pack” on Page 26).
•If the handset's display is blank and the phone does not work, recharge the battery pack. (The battery power might be too low to light the display.)
•If the battery pack becomes weak during a call, the handset beeps every 3 seconds and Low Bat- tery flashes. When this happens, you cannot make another call on the phone until you recharge the battery pack.
•About once a month, fully discharge the battery pack by keeping the handset off the base until Low Battery flashes. Otherwise, the
SETTING THE DIALING MODE
Set DIAL MODE P-
1.Set DIAL MODE P-
2.Press SPEAKER and listen for a dial tone.
3.Press any number other than 0 on the base's keypad.
Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code number either.
9
