DISABLING LINE 2
Should you ever need to disable Line 2, leave the handset in the cradle and press HOLD, LINE 2, then 
.
To enable the Line 2 indicator, leave the handset in the cradle and press HOLD, LINE 2, then #.
SETTING THE DIALING MODE
Set T/P (Tone/Pulse) on the back of the phone for the type of service you have. If you are not sure which type you have, do this test.
1.Press LINE 1.
2.Set T/P to T.
3.Press any number other than 0.
If the dial tone stops, you have touch tone service. Leave T/P set to
T.
If the tone continues, you have pulse service. Set T/P to P.
SETTING THE RINGER
The lines on your phone ring with differ- ent tones when you receive a call. You can set the phone lines to ring at the same volume, at different volumes, or not at all.
To set each ringer’s volume, set RINGER OFF/LO/HI for that line to the desired po- sition.
If you do not want a line’s ringer to sound, set RINGER OFF/LO/HI for that line to OFF. The line indicator will light when a call comes in. You can still re- ceive and make calls on that line.
CONFIRMING THE LINE NUMBERS
Follow these steps to determine which phone number is connected to which line.
1.Press LINE 1 then lift the handset.
2.Dial one of your phone numbers. If the Line 2 indicator flashes, the number is connected to Line 2. If you hear a busy signal, the number is connected to Line 1.
After you confirm the phone number for each line, write each number on the name and number directory located above the L1 and L2 buttons.
11
