Radio Shack ET-926 owner manual Memory Dialing, Storing a Number in Memory

43-1096.fm Page 15 Tuesday, August 17, 1999 3:47 PM

Notes:

•Make sure you press Talk twice to stop the handset from beeping. If you press Talk only once, you get a dial tone.

•If you receive a call while the page is sounding, the handset stops beeping and starts ringing.

MEMORY DIALING

You can store up to 20 numbers in memory, then dial a stored number by pressing a two-digit memory location number.

Each number you store can be up to 16 digits long.

Storing a Number in Memory

Note: An error tone sounds and the phone exits the storing process if you wait more than 30 seconds between each key press.

1. Lift the handset.

2.Press Mem. The Talk/Batt Low indicator blinks.

3.Enter the number and any Tone/

mode changes or Pause entries (see “Entering a Pause” on Page 16).

Notes:

•Each Tone/ or Pause entry uses one digit of memory.

•If you try to enter more than 16 digits, the phone sounds an error tone and exits the storing process. Start over at Step 2.

4.Press Mem again, then enter the two-digit memory location num- ber (01–20) where you want to store the number. The handset beeps twice to indicate that the number is stored.

15