Radio Shack Model 130 Moviecorder owner manual Standard TV

16-830.fm Page 33 Wednesday, July 21, 1999 9:32 AM

Standard TV

UHF IN VHF IN

75-ohm 300-ohm

To connect the camcorder to a standard TV (with only VHF and UHF terminals), you need an RF adapter kit (CMC No. T16-RF71A, not sup- plied). The RF adapter kit includes:

•RF converter

•300-to 75-ohm matching transformer

•75-ohm antenna cable

Cautions:

•Use only the recommended RF adapter kit with this camcorder. You can order the kit from your local Radio Shack store.

•The RF converter is a sealed unit. Do not attempt to open or modify it.

•Do not damage or drop the RF converter or subject it to mechanical vibration.

•Unplug the RF converter during lightning storms.

Notes:

•You do not have to disconnect the RF con- verter when you watch TV broadcasts. Sim- ply set the TV’s tuner as usual.

•Unless your antenna is VHF-only (you receive Channels 2-13 only), you also need a band-splitter (such as Cat. No. 15-1252, not supplied) to connect your camcorder to separate TV VHF/UHF terminals.

1.Use a fingernail to pull down the cover on the camcorder’s AUDIO/VIDEO OUT/IN jack compartment to open it.

Caution: The cover on the AUDIO/VIDEO OUT/IN jack compartment is attached to the camcorder. Do not try to remove it.

2.Connect the RF converter’s plug to the camcorder’s VIDEO, RF DC OUT, and AUDIO jacks.

3.Set AV OUT/IN inside the AUDIO/VIDEO OUT/IN jack compartment to OUT.

4.Disconnect the VHF antenna/cable wire from your TV and connect it to the RF con- verter’s IN FROM ANT jack:

•If the antenna/cable wire is the round, 75-ohm type, connect it directly to the jack.

•If the antenna/cable wire is the flat, 300- ohm type, use another 300- to 75-ohm matching transformer (such as Cat. No. 15-1253, not supplied) to connect the wire to the jack.

33