Occasionally, you might get interference on a weak or distant channel from a strong transmission 21.4 MHz above or below the tuned frequency. This is rare, and the image signal is usually cleared whenever there is a transmission on the actual frequency.
4'5'66+0)1+0+6+#.+<+0)"6*'"5%#00'4
If the scanner's display locks up or does not work properly after you connect a power source, you might need to reset or initialize the scanner. #
4GUGVVKPI"VJG"5ECPPGT"#
1.Turn off the scanner, then turn it on again.
2.Insert a pointed object, such as a straightened paper clip, into the reset opening on the back of the scanner. Then gently press the reset button inside the opening.
+PKVKCNK\KPI"VJG"5ECPPGT
1.Turn off the scanner, then turn it on again.
2.Hold down TUNE/CLEAR.
3.While holding down TUNE/CLEAR, insert a pointed object (such as a straightened paper clip) into the reset opening on the back of the scanner, then gently press the reset button inside the opening. The display should turn off.
4.When the display turns on again, release TUNE/CLEAR.
±
9+4'&"241)4#//+0)
You can transfer programming data to your scanner using your home computer and an optional scanner PC programming kit (Cat. No.
±
1.Make sure your scanner is turned off.
2.Follow the steps provided with the programming kit to connect the cable to your computer and load the
software into your computer, then connect the other end of the cable to 
/PC on the back of the scanner.
3.Using the software supplied with the programming kit, configure the software to work with your scanner by
#"+/2146#06"#
Resetting/Initializing the Scanner
If you have problems, first try to reset the scanner (see “Resetting the Scanner !”). If that does not work, you can initialize the scanner (see “Initializing the Scanner”); however, this clears all information stored in your scanner's memory.
Resetting the Scanner
If the scanner still does not work properly, you might need to initialize the scanner (see “Initializing the Scanner”).
±"016'"±"
Initializing the Scanner
You must release the reset button before releasing TUNE/CLEAR; otherwise the memory might not clear.
Wired Programming
•If the scanner receives no data from the PC for more than 20 seconds or if you press any key, wired programming stops.
•If the scanner did not receive a start bit from the PC, Ij7hj does not appear.
•Wired programming stops if the scanner receives an empty channel number.
Special Features
23
