Resetting the Scanner

If the scanner’s display locks up or stops operating properly, you might need to reset the scanner.

Caution: This procedure clears all the information you have stored in the scanner. Before you reset the scanner, try turning it off and on to see if it begins working properly. Reset the scanner only when you are sure it is not working properly.

XMake sure your scanner is turned off.

YWhile holding down 2, 9, and HOLD, turn on the scanner. After about 3 seconds, the scanner initializes and CLEAr appears.

Follow these steps to restore the 150 preprogrammed frequencies stored in the scanner.

XMake sure your scanner is turned off.

YWhile holding down 3 and E, turn on the scanner. After several seconds, the scanner restores the frequencies and -LoAd-appears.

Beyond the Basics

54

Page 54
Image 54
Radio Shack PRO-83 manual Resetting the Scanner