PREPARATION
SETTING THE PULSE/ TONE SWITCH
Set PULSE/TONE for the type of service you have. If you are not sure which type you have, follow these steps.
1.Set PULSE/TONE on the back of the TAD to TONE.
2.Lift the handset and listen for a dial tone.
3.Press any number other than 0.
If the dial tone stops, you have touch- tone service. Leave PULSE/TONE set to TONE.
If the dial tone continues, you have pulse service. Set PULSE/TONE to
PULSE.
Note: The # and S buttons have no function in the pulse mode.
Notes:
•To avoid resetting the time if AC power is lost, we recommend you install a backup battery before you set the day and time.
•If you do not complete each step within 8 seconds, the TAD sounds three beeps and stops setting the day and time. Start again from Step 1.
1.Press and hold SET until the TAD beeps. The TAD announces, “Sun- day,” and 01 appears on the dis- play.
Note: If necessary, adjust VOLUME on the right side of the TAD to the desired listening level.
2.Press REPEAT/CODE to set back the day or SKIP/MEMO to advance the day until the TAD announces the desired day of the week.
SETTING THE DAY AND TIME
The TAD records the day and time of the call with each phone message. Fol- low these steps to set the day and time.
10
