While playing back the messages, PL (playback) and the number of the cur- rent messages flash on the display. For example, if you have a total of four mes- sages (one old, three new), pressing
PLAY/REPEAT/ 
displays 2 (the first new message).
If there are no messages when you
press PLAY/REPEAT/ 
or PLAY/RPT/8, the TAD announces “You have no mes- sages.”
Notes:
•If the TAD detects a busy signal for more than 5 seconds or silence for more than 8 seconds while record- ing a message, it stops recording and releases the call.
•When you play back messages using handset, the message num- ber does not appear on the display.
To skip to the next message, press SKIP (or SKIP/9 on the handset).
To skip to the previous message, press PREVIOUS (or PREVIOUS/7 on the hand- set).
PREVIOUS/7
To play the current message again,
press PLAY/REPEAT/ | (or PLAY/RPT/8 |
on the handset). |
|
To stop playback before the end of the messages, press STOP (or STOP/HELP/ 
TONE on the handset).
DELETING MESSAGES
To delete the current message, press DELETE, on either the handset or base, until a beep sounds at any time during playback.
DELETE
To delete all messages at once, while messages are not playing, hold down DELETE on the base until the TAD beeps 3 times. After all messages have been deleted, the TAD announces “You have no messages.”
ADJUSTING THE TAD'S VOLUME
You can adjust the playback volume with the VOLUME control, located on the right side of the base, during message playback or call screening.
VOLUME
27
