Rancilio Classe 8 Heating Milk or a Drink TSC, Preparing Frothed Milk TSC, Programming Mod.DE

When the dose of hot water is being delivered electro- nically, delivery can be interrupted by pressing the button 5B.

When purified water is used, these beverages often assume a darker colour.

Should the user prefer a lighter coloured drink, draw fresh water from an ordinary tap and proceed with the heating phase as described in point 8.3.

8.5.Machines with TSC automatic system (Fig.7) (only Mod. DE)

8.5.1Heating Milk or a Drink (TSC)

● Immerse the wand in the drink

● Press button 6.2 on the keypad (Fig.7)

●The display will show the temperature of the drink

●Press button 6.2 again to stop heating at the de- sired temperature.

●Wait for the machine to stop automatically at the programmed temperature.

8.5.2. Preparing Frothed Milk (TSC)

●Immerse the wand in a container containing at least 250 cc of milk (the sensor must be at least 3 cm below the water level).

To obtain best results, use refrigerated milk (≤ 5°C) - (≤ 41°F)

●Press button 6.1 on the keypad (Fig.7)

●The display shows the temperature of the milk.

●Press button 6.1 again to stop the machine at the desired temperature and emulsion level.

●Wait for the machine to stop automatically at the set temperature and level of froth.

8.6 Programming functions

8.6.1 Programming Panel (Mod.DE)

Use the first coffee keyboard with keys having the following functions (Fig.9):

1° Button Enter programming

Keeping pressed for 8 sec. you enter programming, then you have:

(Fig.10)

1° Button “+” To move to a higher level in the programming menus. Or to increase the value

2°Button “-”	To move to a lower level in the
	programming menus. Or to
	decrease the value
3° Button “enter” To enter the programming
	menu. Or to confirm entries
4° Button “esc”	To quit the menu
	Or to quit programming mode.
5° Button	Key off.

8.7 Programming (Mod.DE)

By keeping START/STOP key pressed and switching the machine off and on again, you will enter pro- gramming.

8.7.1 Barman programming (Fig.12)

By keeping key 1 of keyboard 1 pressed for 8 seconds you will enter programming.

By pressing “+” and “-” keys the following sub-menus will be browsed:

Programming with the following sub-menus:

-Clock

-Set date

-Set time

-Date/time format

-Set timer

-Stand by timer

-Sunday

8.7.2.Clock

Sub-menu to set date and time and mode (24 hours or English 12 hours and date with dd/mm/yy or mm/dd/yy)

8.7.3 Set timer

Menu to set automatic switching on/off of the machine as follows:

-select automatic or manual switching on (to enable function or not)

-set switching on time for every day of the week

-set working hours

To browse from one menu to another press “+” or “-”, to enter a sub-menu or to confirm a variation press “enter”, to exit press “esc”.

The value that can be modified with “+” or “-” keys is flashing.

8.7.4 Timer-cut-out (Fig.13)

If the machine is turned off by the program, by pres- sing key 4 of keybord 1 at least for 3-4 seconds it will turn on again and remain on until the following pro- grammed stop or by pressing the same key again.

If the machine is turned on by the program, by pres- sing key 4 of keybord 1 at least for 3-4 seconds it will turn off again and remain off until the following pro- grammed stop or by pressing the same key again.

62