Oven Accessories
The oven is supplied with two wire shelves, 2
Fitting the Telescopic Arms
To fit the telescopic arm, locate the two retaining brackets onto the wire frame. Push the bracket back onto the wire frame until the spring clip ‘snaps’ the assembly to the frame.
The arm is now held in position on the wire shelf by two
Removing the Shelf
Pull the shelf forward until the back of the shelf is up to the shelf stop
Refitting the Shelf
To refit the shelf, line up the shelf with the shelf supports and slide it between the two support wires until the shelf stop hits the wire support. Lift the front of the shelf so that the stop clears the support, then lower the front so that the shelf is level and push it back fully.
The shelf guard should be at the back pointing upwards.
�Fig.2-25
�
�
�
Key
A – Shelf guard, B – Front, C – Shelf stop
����������
�������
���������
�������
����
9