Rangemaster R9044 manual Oven Accessories, To Start and then Stop the Oven using the Timer

To Start and then Stop the Oven using the Timer

This is a semi-automatic function that allows you to set the ‘cook time’, which is the duration you want the oven to cook for and the ‘stop time’, which is the time of day at which you want the oven to stop cooking.

You cannot set a start time directly – this is set by a combination of the ‘cook time’ and ‘stop time’.

Press the timer key for about 3 seconds. Press the key again until ‘dur’ appears in the display (Fig.2-7). Using the ‘+’ and ‘–‘ keys, set the required ‘cook time’. Wait a few seconds for the settings to be memorised.

Press the timer key for about 3 seconds, then press the key twice again until ‘End’ appears in the display (Fig.2-8). Using the ‘+’ and ‘–‘ keys, set the required ‘stop time’.

Note: Make sure to set the temperature control to the correct cooking temperature.

The oven will beep when it stops cooking. To stop the beeper when it sounds, press any of the clock buttons.

Adjusting the Beep Volume

To adjust the beep volume, press the ‘+’ and ‘–‘ keys simultaneously, then press and hold the central timer button until ‘ton 1’ flashes in the display (Fig.2-9).Press the ‘–‘ key to scroll through the volume settings:

•Ton 1: High volume

•Ton 2: Medium volume

•Ton 3: Low volume

Press the central timer key to set the volume.

Oven Accessories

The oven is supplied with two wire shelves and an enamelled grill pan, with a trivet and a handle. The wire shelves slide into the wire supports located on either side of the oven interior

(Fig.2-10).

Removing the Shelf

Pull the shelf forward until the back of the shelf is up to the shelf stop (Fig.2-11). Lift the front of the shelf so the stop clears the wire support and pull clear (Fig.2-12).

Refitting the Shelf

To refit the shelf, line up the shelf with the shelf supports and slide it between the two support wires until the shelf stop hits the wire support. Lift the front of the shelf so that the stop clears the support, then lower the front so that the shelf is level and push it back fully.

The shelf guard should be at the back pointing upwards.

Fig.2-8

ArtNo.303-0005 Setting the end time

Fig.2-9

ArtNo.303-0006 Adjusting the beep volume

�Fig.2-10

�

�

ArtNo.325-0033 Oven BI shelf

�

Key

A – Shelf guard, B – Front, C – Shelf stop

Fig.2-11

ArtNo.325-0034 - Fitting the shelf 1

Fig.2-12

ArtNo.325-0035 - Fitting the shelf 2

5