Main Oven check
The clock must be set to the time of day before the ovens will work.
Push in and turn one of the oven knobs to Mark 9, the timer will run until the ‘cook period’ starts, when the oven solenoid will open and the burner will light automatically. The cooking symbol ( 
) will show. At the end of the ‘cooking period’ the solenoid will close, the oven burner will go out and the beeper will sound (the beeper may be stopped by pressing the timer ( 
) button). The flashing (AUTO) symbol is a reminder to reset to manual operation. Pressing the reset’ button ( 
) once to stop the beep and a second time to return to manual, turn off the oven knob.
CONTROL KNOB (THERMOSTAT) CHECK
Set timer to manual. Check each oven in turn. Push in and turn the control knob to Mark 9. A series of sparks will occur at the oven electrode and when the oven burner lights the sparking will stop. A small flame will appear on the oven burner, but as this flame is ‘sensed’ by the flame supervision device, the gas flow will come on full after a short delay. Heat each oven for 10 minutes at Mark 9 then turn to Mark 1 and check that the flame size has reduced. Turn off each oven and check that the oven burner goes out.
Tall oven
Turn on the Tall oven and check that it heats up.
Press and hold as above.
At the same time, press - or + until the correct time shows.
Don’t forget it’s a 24 hour clock.
If you make a mistake or press the wrong button, turn off the power supply for a minute or two and start again.
CONTROL KNOB (THERMOSTAT) CHECK
If (AUTO) is flashing, press and release the manual
(
) button. Check each oven in turn. Push in and turn the control knob to Mark 9. A series of sparks will occur at the oven electrode and when the oven burner lights the sparking will stop. A small flame will appear on the oven burner, but as this flame is ‘sensed’ by the flame supervision device, the gas flow will come on full after a short delay. Heat each oven for 10 minutes at Mark 9 then turn to Mark 1 and check that the flame size has reduced. Turn off each oven and check that the oven burner goes out.
TIMER AND SOLENOID CHECK
Automatic Operation of Timer: The gas supply to each oven can be controlled by the timer. Set a ‘cooking period’ time by pressing and releasing the (
) button and using the + button to give a time of 2 minutes. By pressing and releasing the ‘stop time’ button ( ) the stop time is displayed. Add 3 minutes to this time by using the + button. The display will automatically change to show the time of day, the cooking symbol
( 
) will go out and (AUTO) will show.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the cooker. Hook the central keyhole over the central screw. Twist and fit each end keyhole over their respective screws. Tighten the fixing screws.
Customer care
Please complete your details in the inside cover of this Guide. Then replace this Installation Guide back in the Customer Care Pack in the correct position. Please inform the user how to operate the cooker and hand over the Customer Care Pack.
Thank you.
29
