Fitting the splash back
The cooker can be installed with or without the supplied splashback. To fi t the splash follow the instructions below.
view from the rear of the cooker
The splash back is fitted using 4 screws in the rear edge of the fl ue grille, two at each end. Remove the outer two screws and loosen the inner pair. Fit the splash over the inner screws and then refi t the outer two screws. (see fi gure).
Fit the Handles
Remove the 4mm Allen screws from the doors with the hexagon key tool. Use the screws to fi t the door handles.
The handles should be above the fixings.
Remove the 4mm Allen screws from the top corners of the facia and fi x the front handrail in position.
Electrical Connection
This appliance must be installed by a qualified electrician to comply with the relevant regulations and also the local electricity supply company requirements.
Make sure that the mains characteristics (voltage, nominal, power, etc.) match the ratings indicated on
the data plate affi xed to the lower right hand cooker upright (remove storage drawer). The cooker is preset for a
It is essential to install a
WARNING: THIS APPLIANCE MUST BE EARTHED
The appliance must be connected to an efficient earthing circuit. If the electricity network is not equipped with an earth connection, then it must be installed separately in compliance with local regulations. Earthing is a safety measure required by law, and must be performed with particular care by a qualifi ed technician, who must also check that the electricity supply characteristics are correct.
The cable size used should be suitable for the appliance load and in accordance with local regulations. Please note the maximum cable sizes are 6mm2 for the screw terminals and 10mm2 for the 3 pronged links.
Access to the mains terminal is gained by removing the electrical terminal cover box on the back panel. Connect the mains cable to the correct terminals for your electrical supply type (see fi g.).
Check that the links are correctly fitted and that the terminal screws are tight.
Secure the mains cable using the cable clamp.
31
