Raypak 185A manual Shield Brackets

Page 12

PLASTIC SHIELD & BRACKET INSTALLATION - MODELS 185, 265, 335 & 405, A & B SERIES:

Make sure the power and gas are off.

1.Note that the plastic shield is installed under the front bracket as pictured.

Install the shield brackets and plastic shield using the existing screws on the control panel as shown in Fig. 32.

2.Reconnect the wire harnesses to the board. (Note the location of the clear plastic strip with the thin connector. This is sometimes disconnected when there is a remote control in the system. Refer to the remote wiring instructions for further details.)

Note: Make sure 3-wire sensor plug is connected.

3.Install the plastic shield over the board and attach to the brackets using the screws and washers provided in the kit. See Fig. 33 and Fig. 34.

4.Re-install the sheet metal panel holding the board back into the heater.

5.Go to remote operation instructions.

OR

Return the control panel to the upright position and re-attach using the screws previously removed.

P/N 241169 Rev.-3

SHIELD

BRACKETS

CLEAR PLASTIC STRIP WITH THIN CONNECTOR

Fig. 32

Fig. 33

SIDE VIEW

Fig. 34

2151 Eastman Ave., Oxnard, CA 93030 805-278-5300 Fax 800-777-7026 www.raypak.com Technical support is available M-F, 5:30 AM to 5:00 PM PST, at 800-947-2975 or 800-627-2975