Contents
P.C. BOARD, TEMPERATURE CONTROL & SENSOR KIT #010253F FOR ALL
RAYPAK REPLACEMENT INSTRUCTIONS
This kit includes
IMPORTANT NOTICE
ACCESSING THE BOARD - MODELS
ACCESSING THE BOARD - MODELS 185A/B, 265A/B, 335A/B, 405A/B
206A, 207A, 266A, 267A, 336A, 337A, 406A, 407A
Fig. 4 Close-up
UNPLUG ALL CONNECTORS
REMOVING THE CIRCUIT BOARD - MODELS 185A/B, 265A/B, 335A/B, 405A/B
P/N 241169 Rev.-3
REMOVE KEYBOARD RIBBON
1. Unplug all connectors from old circuit board. Fig
Make sure the power and gas are off
UNPLUG ALL CONNECTORS REMOVE KEYBOARD RIBBON
2. Unplug keypad ribbon from old circuit board
1. Unplug all wires and connectors from ignition control. See Fig
Make sure the power and gas are off
UNPLUG ALL WIRES
can be left in place but not used
Make sure the power and gas are off
PROPANE HEATERS ONLY
1. Locate the propane tab on the board as shown in Fig
2. Break off tab with pliers as shown in Fig. 13 & Fig
Make sure the power and gas are off
MODELS 185, 265, 335 & 405, A & B SERIES, LOW NOX ONLY
2. No additional wiring or connections are necessary
1. DO NOT break tab See Fig. 15 and Fig.16
BREAK TAB WIRE AIR SWITCH TO P-10 HERE
LOW NOX MODELS 207A, 267A, 337A & 407A
P/N 241169 Rev.-3
LO NOX
335 & 405, A & B SERIES
NEW CIRCUIT BOARD & GASKET INSTALLATION USING OLD BEZEL - MODELS 185
REMOVE BACKING
LAY BOARD DOWN
LAY BEZEL DOWN
REMOVE BACKING
Page
SHIELD BRACKETS
INSTALLING PILOT HI TENSION 206 TO 267A
Ensure the power and the gas has been shut off
INSTALLING PILOT HI TENSION WIRE EXTENSION SIZES 335A TO 407A
Ensure the power and the gas has been shut off
Page
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3