Contents
This kit includes
RAYPAK REPLACEMENT INSTRUCTIONS
P.C. BOARD, TEMPERATURE CONTROL & SENSOR KIT #010253F FOR ALL
IMPORTANT NOTICE
206A, 207A, 266A, 267A, 336A, 337A, 406A, 407A
ACCESSING THE BOARD - MODELS 185A/B, 265A/B, 335A/B, 405A/B
ACCESSING THE BOARD - MODELS
Fig. 4 Close-up
P/N 241169 Rev.-3
REMOVING THE CIRCUIT BOARD - MODELS 185A/B, 265A/B, 335A/B, 405A/B
UNPLUG ALL CONNECTORS
REMOVE KEYBOARD RIBBON
UNPLUG ALL CONNECTORS REMOVE KEYBOARD RIBBON
Make sure the power and gas are off
1. Unplug all connectors from old circuit board. Fig
2. Unplug keypad ribbon from old circuit board
UNPLUG ALL WIRES
Make sure the power and gas are off
1. Unplug all wires and connectors from ignition control. See Fig
can be left in place but not used
1. Locate the propane tab on the board as shown in Fig
PROPANE HEATERS ONLY
Make sure the power and gas are off
2. Break off tab with pliers as shown in Fig. 13 & Fig
2. No additional wiring or connections are necessary
MODELS 185, 265, 335 & 405, A & B SERIES, LOW NOX ONLY
Make sure the power and gas are off
1. DO NOT break tab See Fig. 15 and Fig.16
P/N 241169 Rev.-3
LOW NOX MODELS 207A, 267A, 337A & 407A
BREAK TAB WIRE AIR SWITCH TO P-10 HERE
LO NOX
REMOVE BACKING
NEW CIRCUIT BOARD & GASKET INSTALLATION USING OLD BEZEL - MODELS 185
335 & 405, A & B SERIES
LAY BOARD DOWN
REMOVE BACKING
LAY BEZEL DOWN
Page
SHIELD BRACKETS
INSTALLING PILOT HI TENSION WIRE EXTENSION SIZES 335A TO 407A
Ensure the power and the gas has been shut off
INSTALLING PILOT HI TENSION 206 TO 267A
Ensure the power and the gas has been shut off
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3
Page
P/N 241169 Rev.-3
Page