2 SpeedTouch™ Installation
E-SIT-CTC-20030702-0003v4.0
22
2.2.2 Installation for Mac OS X
Supported Operating
Systems
The following OS must be readily installed on your computer:
•Mac OS X v10.1, v10.2 and v10.3
Note Mac OS X v10.0 users must download the free upgrade to Mac OS X v10.1
to be able to install and use the SpeedTouch™ device.
Minimum system
requirements
For Mac OS X v10.1:
•121 megabytes (MB) of free disk space (during installation process)
For Mac OS X v10.2 and v10.3:
•21.6 megabytes (MB) of free disk space (during installation process)
The SpeedTouch™
Installation
The SpeedTouch™ installation consists of two major parts:
•The software installation procedure
•The hardware installation procedure
If you want to connect to the Internet via a PPP (PPPoA or PPPoE) connection some
additional configuration is required.
Mac OS X differences Depending on the Mac OS X version your computer runs, some windows may differ
from the windows shown in the installation procedures.
The driver installation
procedure
Proceed as follows:
1Insert the SpeedTouch™ Setup CD-ROM in your computer's CD-ROM drive and
open the OSX folder.
2Open the Setup folder.
3Depending on your Service Provider’s specifications open either the:
•WAN folder
to install a PPPoA connection or a PPPoE connection
•LAN folder
to install an RFC1483 Bridged connection.
4In this folder open the folder corresponding to your local setting (this should be
specified by your Service Provider) and double-click SpeedTouchUSB.pkg to start
the installation procedure.
Note If your computer runs Mac OS X v10.1 or v10.2, the installation wizard
may prompt you for authentification. If this is the case, click to
enter your credentials.
Note If your computer runs Mac OS X v10.3, your computer will prompt
you to run a program to determine if the installer package can be
installed. Click Continue.