Step 6: Connect the rear section to the middle (large) section
| Screw | |
Rear | Middle | |
section | ||
section | ||
| ||
| Nut | |
| Fig. 6 |
On the open end of the middle (large) section, remove the rear nut and screw.
Find the rear section. Slide the narrow boom of the rear antenna into the middle (large) section. Tap lightly with a rubber mallet on the end of the small boom, aligning the holes for the screw. (See fi gure 6.)
Step 7: Connect the phasing lines
Phasing | Nut | |
line | ||
Washer | ||
| ||
| Stud | |
Fig. 7 |
|
On the middle (large) section, near where the middle and rear sections come together, fi nd the posts on the top and bottom of the last element holder studs. (See fi gure 7.)
Place the phasing lines from the rear section over the studs, one on the top side and one on the bottom. Then fasten them to the posts with washers and #10 fl ange nuts. Tighten securely.
4
