RCA CRT Television Testi NG TH E Remote, Prog Rammi NG TH E Remote, Using Automatic Code Search

PROGRAMMING TH E REMOTE

The universal remote can be programmed to control most brands of remote controllable VCRs, satellite receivers and cable boxes. The remote is already programmed to control most RCA, GE, and PROSCAN TVs, VCRs, DVD players, laserdisc players and satellite receivers.

TESTI NG TH E REMOTE

To determine whether the universal remote needs to be programmed, turn a device ON, such as a VCR, point the remote at the VCR, and press the VCR1 button. Then press ON.OFF or CH ^ (channel up) or CH v (channel down) to see if the VCR responds to the remote commands. If not, the remote needs to be programmed.

PROG RAMMI NG TH E REMOTE

Using Automatic Code Search

The following instructions can be used to program the remote to

control each of the devices connected to your TV. If you want to exit the

automatic code search without programming any of your devices, press

and hold CLEAR until the LED turns off.work with the AUX button in this model.

I Note: Programming the remote will not 1

1.Turn on the device you want to control (VCR, SAT, etc.).

2.Press and hold the button you want to program (VCR1, VCR2, etc.). While holding the device button, press and hold ON.OFF until the

									S
	red light on the remote turns on, then release both buttons.
3.	Press and	release	PLAY, then wait	5 seconds		or until the	LED stops		DW vc_2 _ux SA_.CA_E
	flashing.
	At this point the remote is searching for the correct code to
	program. If, after 5 seconds, the device you want to control does
	not turn off, press PLAY again to tell the remote to search the next
	set of codes.
	Continue pressing PLAY until the device turns off or you have
	searched	through	all of the codes. There are			20 total sets of codes.
	If the device does		not turn off after		pressing	PLAY 20 times,		then
	the remote cannot control that particular device.
If the device you want to control does turn off:
1.	Press and	release	REVERSE,then	wait 2 seconds. Repeat			this	step
	until the device turns back ON.
2.	To finish,	press and hold STOP until			the red	light on the	remote
	turns off.

Using Direct Entry

1.Turn on the component to be programmed.

2.Look up the brand and code number(s) for the component on the code list on the last page of this section, Using the Remote.

You'll use these buttons when you program the remote to control any device.

The remote may not operate all models of all brands.

24