RCA F27669 manual Connection TV + VCR + Cable Box

Connections & Setup

VCR

TV

Cable

Box

SIGNAL SPLITTER

From Cable Line

1A

CABLE BOX

1C CABLE IN TV OUT

VCR

1B		VIDEO	AUDIO	L
			R
	ANTENNA IN		OUT
			IN
			R	L
	3B	3A
	TV
	VIDEO		AUDIO
		R	L / MONO
				IN
4	G-LINK			CABLE/
				ANTENNA
				S-VIDEO

2

Note: The GUIDE Plus+ system’s One-Touch VCR Recording feature is not available with this connection. If you want to use the One-Touch VCR Recording feature with your cable box, you must use the TV and VCR connection on page 8. You can do so by routing the signal from your cable box into the antenna input on your VCR. Note that PIP won’t work if you use this connection. This connection may not be compatible with all cable services, especially if some or all cable channels are scrambled.

Connection: TV + VCR + Cable Box

1.Connect Signal Splitter to your VCR and TV

A.Use a Signal Splitter (not provided) to split the signal coming into the room. You can purchase a Signal Splitter at your local electronics store or through the Accessory Order Form on

page 59.

B.Connect a coaxial cable to Signal Splitter and to the Input Jack on the VCR (sometimes labeled

ANTENNA IN).

C.Connect a coaxial cable to the Signal Splitter and to the CABLE IN Jack on the cable box.

2.Connect Cable Box to TV

Connect a coaxial cable to the TV OUT Jack on the cable box and to the CABLE/ANTENNA jack on the TV.

3.Connect the TV to your VCR

A.Connect the audio cables (white and red) to the AUDIO IN jacks on the TV and to the Audio Output Jacks on the VCR (sometimes labeled AUDIO OUT R and L).

B.Connect the video cable (yellow) to the VIDEO IN jack on the TV and to Video Output Jack on the VCR (sometimes labeled VIDEO).

4.Connect G-LINK cable

A.If you haven’t already done so, remove the Demo Pin from the G-LINK jack on the TV.

B.Connect the G-LINK cable to the G-LINK jack on the TV. Next step, place the wands of the G-LINK cable to work with the VCR and cable box (instructions are on p. 13).

Go to page 13

12 Chapter 1