RCA Fibre Channel Switch Configuring your Fibre Channel switch, Verify firmware version

Configuring your Fibre Channel switch

AdminTimeout	(dec value 0-1440 minutes, 0=never)	[30]
TempMonitoringWarning	(dec value 0-100 degrees Celsius)	[65]
TempMonitoringFailure	(dec value 0-100 degrees Celsius)	[70]
TempFailurePortShutdown	(True / False)	[False]
SecurityEnabled	(True / False)	[False]
LocalLogEnabled	(True / False)	[True]
RemoteLogEnabled	(True / False)	[False]
RemoteLogHostAddress	(dot-notated IP Address)	[10.0.0.254]

Do you want to save and activate this system setup? (y/n): [n] y

Verify firmware version

You can use the show switch command to view switch information and confirm that the active firmware version is correct. The minimum qualified image is:

• 1.5.0.8 or higher

Contact your Grass Valley representative to determine the current required version.

To view the current version information:

1.In administrator mode type the following command at the prompt,: sb5_8port (admin) #> show switch

2.View the switch information, an example of which is shown here. Note that the ActiveSWImage specifies which SWImageVersion is being used. In this case, it’s image 2.

Switch Information
------------------
SymbolicName	sb5_8port
SwitchWWN	10:00:00:c0:dd:01:a6:47
SwitchType	Sanbox2-8C
PROMVersion	V1.4.0.2-0 (Thu Mar 13 21:27:06 2003)
CreditPool	0
DomainID	100 (0x64)
FirstPortAddress	640000
FlashSize - MBytes	128
LogLevel	Critical
MaxPorts	8
NumberOfResets	17
ReasonForLastReset	PowerUp
SWImageVersion (1) - build date	V1.4.0.39-0 (Tue Jan 21 08:11:16 2003)
SWImageVersion (2) - build date	V1.5.0.8-0 (Thu Mar 13 21:27:06 2003)
ActiveConfiguration	default
ActiveSWImage	2
AdminState	Online
AdminModeActive	True
BeaconOnStatus	False
OperationalState	Online
PrincipalSwitchRole	False

16 April, 2003 Fibre Channel Switch 15