RCA HD61LPW164 manual 2A1, How to Connect TV + Satellite Receiver + VCR

Connections & Setup

SATELLITE

RECEIVER

VIDEO R AUDIO L S-VIDEO

TV

3

Satellite Receiver

TV

	FIXED/VARIABLE AUDIO OUTPUTS
CENTER SPEAKER INPUT	CENTER	R REAR	L REAR
EXTERNAL AMP				MATRIX
MAX POWER RATING!				SURROUND
(60 WATTS into 8 OHMS)				OUTPUTS
						AUDIO/VIDEO
						OUTPUT
	SUBWOOFER	R	L	WIRED	R	L	V
				IR
POWER
(AC 120V~60Hz)
DIGITAL
AUDIO				CableCARD™
ETHERNET OUTPUT

2B

	COMPOSITE INPUTS				COMPONENT/COMPOSITE INPUTS
					Use menu for composite video.
	INPUT 3	V				INPUT 4
R	L		S-VIDEO	R	L	PR	PB	Y/VIDEO
R	L	V	S-VIDEO	R	L	PR	PB	Y/VIDEO
	INPUT 1					INPUT 2
		CABLE				ANTENNA INPUT
			INPUT	FACTORY USE ONLY

HDMI/DVI INPUT

Use menu for DVI audio.

2A1

OFF-AIR ANTENNA

VCR

VCR
ANTENNA IN	R AUDIO L	VIDEO	R	AUDIO L	VIDEO
	IN		OUT	O	1
ANTENNA OUT

CABLE

How to Connect: TV + Satellite Receiver + VCR

1.Connect your cable and/or off-air antenna.

If you have cable and an off-air antenna, connect the cable signal to CABLE INPUT. Connect the off-air antenna to

ANTENNA INPUT.

2.Connect your VCR to your TV.

A.Connect the VCR’s audio/video outputs to INPUT 1 (R and L-Audio, and V-Video) on the TV using composite audio/ video cables.

B.Connect the VCR’s audio/video inputs to the AUDIO/VIDEO OUTPUT jacks on the TV. This enables recording of digital and analog programs (except copy protected or component video formats).

3.Connect your Satellite Receiver to your TV.

Connect the satellite receiver’s audio output jacks to the INPUT 3 R and L Audio jacks and the S-Video output jack to the S-VIDEO jack on the TV using audio cables and an S-Video cable. If your satellite receiver doesn’t have an S-Video output, you can make the video connection by using the V (Video) jack instead. If your satellite receiver has component outputs, then use INPUT 2 or 4.

Note: If you are using an S-Video cable or component video cables, you must also connect audio cables. The S-Video cable and component video cables only transfer video information.

Viewing the Components

1.Turn on the TV and the component(s) you want to view.

2.Press the TV button on the remote control.

3.Press the INPUT button on the remote control to scroll through the Video Input Channels.

•View the VCR on the INPUT 1 channel.

•View the satellite receiver on the INPUT 3 channel.

Note: You can set up the TV to automatically tune to the correct Video Input Channel. This is called Auto Tuning. (See Chapter 3 for more information.)

Go to page 21

16 Chapter 1