Connections and Setup
Rear Jack Panel
REAR PANEL
|
| COMPONENT IN 1 |
| AUDIO 1 |
| |
VGA | VGA | Pr/Cr Pb/Cb | Y |
| L IN R | ANTENNA |
| AUDIO |
|
|
|
|
|
COMPONENT IN 2 | AUDIO 2 | AUDIO OUT | VIDEO | DIGITAL | ||
Pr/Cr Pb/Cb | Y | L IN R | R | L | OUT | ANTENNA HDMI/DVI |
SIDE PANEL
PENDANT DSCI PORT | AUDIO |
|
|
| |
| R IN L | VIDEO |
|
| IN |
Hospital Pendant
This specialized remote control is recognized for use in patient beds. It is used to connect to a pillow speaker, nurse- call system, or other device to supply
Start-up
Plug in the TV
Plug the end of the power cord into the back of the TV. Plug the other end into a grounded wall outlet. Insert the plug completely into the outlet. Do not plug into an outlet controlled by a light switch.
Put Batteries in the Remote
•Remove the battery compartment cover from the back of the remote by pushing the tab and lifting off the cover.
•Insert two fresh batteries. Make sure the polarities (+ and
•Replace the cover.
Turn on the TV
Turn on your TV by pressing the Power button on the front of the TV or ON•OFF on the remote control.
Place All Available Channels Into Memory
1.To go to the Setup menu, with the master remote (CRK17TD1), press MENU then select Setup. In this menu you'll be able to set your Signal Type. Next go to Auto Channel Search, the TV will search for all channels viewable through your antenna or cable TV system.
2.Select which channel list you’d like to find channels for (List A is the default).
3. Press the down arrow button to select Start. Press the OK button to start searching. The TV searches for active channels and places them in the channel list.
Note: Video Input Channels (VID, SVID, etc.) must be added to the active channel list separately before they can be accessed. Refer to the Setup menu section at the end of this chapter for more information on the Channel menu and List & Labels.
Chapter 1 |
