RCA L46FHD37R warranty Protect Against Power Surges, Safety Information, Avoid Audio Interference

1 Connections and Setup

Before Initial Setup

Protect Against Power Surges

¥Connect all components before you plug any power cords into the wall outlet or power strip. NEVER plug your TV into an outlet that is controlled by a wall switch.

¥Turn off the TV before you connect or disconnect any cables.

¥Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions.

Safety Information

¥Protect components from overheating.

¥DonÕt block ventilation holes on any of the components. Arrange the components so that air can circulate freely.

¥DonÕt stack components.

¥If you place the component in a stand, make sure you allow adequate ventilation.

¥If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it wonÕt harm other components.

Avoid Audio Interference

¥Position cables properly; insert each cable firmly into the designated jack.

¥If you place components above the TV, route all cables down one side of the back of the TV instead of straight down the middle.

¥If your antenna uses 300-ohm twin lead cables, do not coil the cables.

¥Keep twin lead cables away from audio/video cables.

Avoid Direct Light

DonÕt place the TV where sunlight or room lighting is directed toward the screen. Use soft or indirect lighting.

Check Supplied Parts

Check that the following parts were packed with your product.

Replacing your remote If you need to replace your remote, call

1-800-257-7946. A shipping and handling fee, and the appropriate sales tax, will be charged upon ordering. Please have your Visa or

RC246

2 AAA BATTERIES

only for model L40FHD41

ST-SCREW STAND CAP

MasterCard ready.

REMOTE CONTROL

PART # RC2463001/01

	only for model L42FHD37R/
	L46FHD37R	CABLE MANAGE-
POWER CORD	STAND CAP
		MENT STRAP

6

Chapter 1 Connections and Setup

Graphics contained within this publication are presentation only.