RCA MM27110 manual Placing the Wands Under the VCR AND/OR Cable BOX, Front Inputs

MAKING CONNECTIONS

Cable Box

CHANNEL

03

VCR

3.Slowly move the remote control across the front of the component (VCR or cable box) while you press the power button on and off. You must press and release the power button each time you move the remote (holding down the button won’t work).

4.When the component turns on, you’ve located the sensor.

5.Place the wands of the G-LINK cable underneath your VCR and/or cable box (see instructions below).

PLACING THE WANDS UNDER THE VCR

AND/OR CABLE BOX

Place the wands of the G-LINK cable underneath your VCR and/or cable box. Place them about one inch away from the remote control sensor.

VCR

SENSOR SENSOR

CHANNEL

03

If you don’t have a VCR, just coil the cable of the extra G-LINK wand with a twist tie and leave it behind the TV.

Connect to G-LINK jack on the back of the TV.

If you don’t have a cable box, just coil the cable of the extra G-LINK wand with a twist tie and leave it behind the TV.

FRONT INPUTS

The monitor has front inputs for convenience; one set of audio/video (A/V) inputs, a headphone jack and two client USB ports. Look for a hinged door and gently lift the cover open. Please note that the illustration below shows a typical front input layout. The exact look of the jacks or monitor pictured here may be different than yours.

A/V jacks USB ports

Headphone jack

NOTE

When you plug in headphones, the monitor’s internal and external speakers are automatically turned off.

When connecting a device that uses a monaural cable, such as some camcorders, use the left input jack to get sound from both speakers.

16