RCA pmn Connecting Your DSS Receiver to Your TV, Things to Know Before Connecting Components

Models: pmn

1 80
Download 80 pages 40.62 Kb
Page 10
Image 10

FIRST THINGS FIRST

CONNECTING YOUR DSS® RECEIVER TO

YOUR TV

During the satellite dish installation, the receiver may have been connected to your TV with just a coaxial cable for the system test. Depending on what components you have, another connection may provide better picture and audio quality. The following sections provide cable and connection information to help you decide what connection is best for you.

THINGS TO KNOW BEFORE CONNECTING

COMPONENTS

Protect Your Components from Power Surges

Connect all components before plugging any power cords into the wall outlet.

Always turn off the DSS® receiver, TV and other components before you connect or disconnect any cables.

Position Cables Correctly to Avoid Audio Hum or Interference

Insert all cable plugs firmly into their jacks.

Place the audio/video cables to the sides of the TV’s back panel instead of straight down the middle after you connect your components.

Try not to coil any twin-lead cables and keep them away from the audio/video cables as much as possible.

Make sure all antennas and cables are properly grounded. Refer to the Safety Tips sheet packed with your unit.

Protect Your Components from Overheating

Do not block ventilation holes in any of the components. Arrange the components so that air can circulate freely.

Do not stack components.

Allow adequate ventilation when placing your components in a stand.

Place an amplifier or DSS® receiver on the top shelf of the stand so heated air rising from it will not flow around other components.

8

Page 10
Image 10
RCA pmn manual Connecting Your DSS Receiver to Your TV, Things to Know Before Connecting Components