RCA RCU1000B warranty VCR/DVD Punch-Through, VCR Record, RCA All Power Off Feature, General Notes

RCU1000B_IB.qxd 10/9/01 11:10 AM Page 28

Setting More Options continued

5. If TV was selected, go to step 6 below. If Audio was selected, the display shows the “Set VolumeÉ. AudioMode?” prompt for Audio Mode to be used for Volume/Mute control. Press and release desired Audio Mode and press and release OK to confirm to save.

6. The LCD displays “Set more Options”. Press EXIT on the LCD.

Notes

VCR/DVD Punch-Through

The remote will punch-through to VCR or DVD mode, whichever was last used. Punch- through to VCR/DVD Mode carriage keys is only allowed for TV, VCR, DVD, and Cable coded Modes. SAT/DBS and CD/Audio are dedicated to their Modes. The LCD shows device change for the VCR/DVD punch-through keys if they are pressed in other Modes, e.g. if you are in Cable Mode and you press PLAY, VCR (or DVD) is displayed in the LCD.

VCR Record

In VCR Mode (including punch-through), the RECORD key has to be pressed twice before the command is sent. This is also true if a VCR type is programmed under any other device. The exception is for DVD where the RECORD key transmits the IR command after only a single press of RECORD. For any programmed SAT/DBS Mode the RECORD key only needs to be pressed once. In any CD/Audio Mode, the RECORD key must be pressed twice.

RCA All Power Off Feature

This feature is available in all normal operating Modes. If the POWER key is pressed consecutively twice within 2 seconds ALL RCA equipment will be turned off. The LCD shows “Power Off” while this routine is active.

General Notes

1.When in Setup Mode, pressing the LEARN key jumps you to the “Learn IR Mode?” screen.

2.When in Setup Mode, pressing the MACRO key jumps to the “Setup a Macro?” screen.

3.At any point in Setup, where a “save” is being made, “Confirm to Save?” is displayed. You then press [OK] to save, or [EXIT] to return without saving any changes.

4.At any point in Setup, where an “overwrite” is being made e.g. overwriting Macro’s, Learned Modes, etc., “Confirm to Overwrite?” is displayed. You then press [OK] to confirm the change, or [EXIT] to return without any saving any changes.

5.At any point in Setup, where a “deletion” is being made e.g. deleting Macro’s, Timers, etc., “Confirm to Delete?” is displayed. You then press [OK] to confirm the deletion, or [EXIT] to return without deleting anything.

6.At any point in Setup, where a “change” has been made a “Success” message is displayed for 1 second to confirm the action.

28